BC Racing DS Type DN for Abarth 500/595/695 2007 - coilover suspension kit
Coilover kit for Abarth 500/595/695 2007->
DS series type DN (no camber plates)
Height, spring pre-load and damping adjustments
Digressive piston design
Delivery time between 5 and 25 days
Coilover kit for Abarth 500/595/695 (2007-).
BC Racing's DS Coilover system is built with digressive valving offering the same great benefits of the BR Type model and is considered a perfect choice for those who are looking for track biased coilovers. The digressive piston design gives a non linear damping curve which allows higher low speed damping to be run to control body roll through cornering, acceleration and braking whilst providing reduced high speed damping to allow the wheel to travel whilst running kerbs to prevent the impact from transmitting fully into the shell so retaining car balance.
The kit comes with spring rates of 5 kg/mm front and 5 kg/mm rear or 4 kg/mm front and 5 kg/mm rear.
INDICATE AT CHECKOUT WHICH COMBINATION YOU PREFER.
- Monotube dampers, oil + pressurized nitrogen with digressive piston design
- 30 way adjustable damping compression+rebound combined
- Linear springs, standard rates 5 kg/mm front, 5 kg/mm rear or 4 kg/mm front, 5 kg/mm rear.
- Adjustable spring platform
- Height adjustment via bottom mount to retain full damper travel
- Dust boot to protect damper seals
The DS series coilovers use a large 46mm diameter piston in a 53mm diameter damper body to maximise oil capacity.
This kit is ideal if you use the car both on the track / mountain and for long journeys. The hydraulics that can be set to 30 clicks allow you to adjust the hardness of the shock absorbers and the behavior of the car as desired
The hardness of the springs is a good compromise between comfort and performance.
It is mounted on original rubber topmounts but thanks to the slots on the shock absorber body it is possible to adjust the front camber up to 2.2º.
On request, it is possible to purchase the kit with different front spring rate.
Available stainless steel centering collar for rear axle and front subframe. These bushings, identical to those fitted on the Assetto Corse, allow the rear axle and the front subframe to be centered with the vehicle chassis.
For configuration, availability, delivery times and other information:
tel/Whatsapp: +39 331 9622326
Mail: info@gardustech.com