- Out-of-Stock
CLOSED FOR HOLIDAY 21/12-02/01
Eventuri BMW F80-F81 M3 / F82-F83 M4 Carbon Air Intake
Cold Air Intake for BMW 3 Series M3 F80 Sedan - F81 Touring / 4 Series M4 F82 Coupé - F83 Cabriolet 3.0 Twin Turbo
Available in Glossy Black Carbon
Made in UK
If not in stock and not available for purchase contact us for the delivery time.
GARDUS TECHNOLOGY IS THE OFFICIAL DEALER FOR ITALY OF EVENTURI PRODUCTS
The Eventuri cold air intake for the BMW 3 Series M3 F80 Sedan - F81 Touring / 4 Series M4 F82 Coupé - F83 Cabriolet 3.0 Twin Turbo has been developed from scratch to get the highest performance possibile, without any restrictions or compromise, with the full optimization of the air flow and temperature.
At the same time the look of the kit has be refined to the highest level, with the same carbon fibre weave as the M Performance OEM parts.
The performance are verified on the dynamometer. On the development car the power went from 449,3 to 466,7 hp at the crank, +17,4 hp without any other modifications.
Each intake system consists of:
- 2 Carbon Fibre Venturi housings
- 2 High Flow Double Cone Air Filters
- 2 Aluminium Cowls for smooth airflow entry
- Left Side Carbon Tube with integrated MAF sensor mount
- Right Side Carbon Tube with integrated MAF sensor mount
- 2 Carbon Fibre Intake sealed Ducts
- 2 Carbon Fibre Front Scoops
- Laser Cut Stainless Steel Brackets
- High quality Silicon couplers with BMW specification hose clamps
The air ports are placed behind the front grills.
The reverse filter cones and the the housing are designed to remove any restriction and step, usually found in other direct air intake using a cone filter. The smooth reduction accelerates the air for maximum flow, and the carbon avoids the heat soak.
The filter housings are positioned with the openings sealed against the carbon ducts. These ducts have been designed to fit over the stock cold air ducting channels and direct ambient air into the filters. These ducts seal the openings of the filter housings and prevent heated air from entering the filters.
To allow free movement to the engine the kit is mounted on a stainless steel + rubber bracket.
For the development the most modern technologies were used: 3d scan for the available room, Computerized Flow Dynamic calculations for the design, 3d printing for the prototype.
In this video is possible to observe the air flow going from the front ports to the engine:
For more information and a quote please contact us by email at : info@gardustech.com
tel/Whatsapp: +39 331 9622326
Alternatively, visit the manufacturer's website: http://www.eventuri.net/products/bmw-f8x-m3m4/